I have two LS220D 4Gb 2 Disk systems and I use one to hold copies of the shares on the other.
I updated both to 1.74 and everything seemed OK but....
Nas Navigator sees both devices and I can go into settings on one and everything is fine.
Going into settings on the other device it never gets past the message "Reading Please wait"
I did a factory reset and it went into initial setup alright. After I had reset passwords and folder access I did a reboot and the settings page shows "Reading Please wait" again. However the device appears to be 'working' I can access shares and use it as the target of backups from the other device. However i can't manage the device / create shares etc.
Any suggestions welcome!
Thanks
Phil