LS_CHL blue leds flashing

[tud]

   

Hello,

 

I own a 1.5 LS-CHL and yesterday I formatted it from web admin but after that it restarts with both status and function leds flashing with blue light.

I cannot turn it off because it coes on with blue flashing leds.

NAS navigator doesn't see it in the network.

What can I do?

 

thanks

[PCPiranha]

Sounds like it may have lost its boot image, try the TFTP procedure

[tud]

   The problem was the ethernet cable not correctly plugged in.... Now i have another problem: E06 error I can boot with TFTP procedure but, after that, both NasNavigator and LSupdater don't find my LinkStation Any other suggestion? Thanks .Stefano

[PCPiranha]

Does the TFTP pull the files, if so it should be found with the NAVI.  If it isn't then you have a bad HDD.  You can contact our support department for an RMA if the units under warranty.

[tud]

   

Thanks for the answer

Just to be sure the HDD is bad I describe what I did

I started TFTP following FAQ 3 when the red light (E06) flashed using trick "Some user have reported that after the device shows the error, holding the function button down for 5 seconds can provoke the TFTP requests." described in the FAQ post.

TFTP started but LED flashed with color blue forever (I've waited for 3 hours)

 

I bought LS 10 days ago in Italy, what can I do for RMA?

 

Thank you

.Stefano

[PCPiranha]

Italy support line is 848 782113

 

Mon-Fri 10-1800