All of a sudden, I can't access

[mgrammas]

   

I have a linksys pro duo that has been working fine for about six months.  Tonight, it started acting up a little in that I couldn't delete any files from the drive.  I looked at the device, and the power light was flashing.  I tried restarting it remotely via the web interface, and it disconnected alright, but never came back.  I then tried powering it down via the power switch.  I let it sit at the "off" position for about five minutes, but it never shut down.  I finally pulled the power cord and it shut down, but as soon as I turned it back on, same thing - flashing power light and network connection light, but I cannot access the drive.  The Buffalo NAS Navigator software doesn't show the device either.

 

Any suggestions?

 

 

Thank you in advance,

 

Mike Grammas

Message Edited by mgrammas on 08-02-2009 10:54 PM

[Kameran]

What was the flashing light doing, 4 flashes 6 flashes?  Also you can try doing a direct connect to a desktop with a cat5e or cat6 cable.  Set a static to 192.168.11.50 ip, and sub of 255.255.255.0.  Before starting up the device hold the function button or reset button for 6 seconds.  Then flip it to on, release function/reset button and press it again, both top and bottom front lights should blink and should have an ip of 192.168.11.150.  See if you can get into the device get data off or try to flash the firmware.