LS-WX1.0TL/1D-R 2 I/O error of HD

[jwlove59]

I bought a unit that shipped with 1 1TB Seagate HD and bought a 2nd Seagate HD to install so I could have a 1TB raid 1 storage.  However as soon as I installed the 2nd HD and powered up the NAS the power light flashes a few times and then the INFO/ERROR light starts flashing code 15. No matter what I have done i.e. formatting the HD and reinstalling them this happens.  According to the manual the code is for a slow data transfer but I let the system set for 10 hours and it was still flashing.   Any help anyone?

[sethz]

This can take up to 12-24 hours per TB.

[jwlove59]

Sorry I was looking at the wrong Error code.  The correct error is I/O errior of hard drive.  I did call tech support, got some help, but now the problem is after running the EM boot, I'm trying to for the firmware to the disk, but I keep getting a NO PERTITION FOUND error and then the program shuts down, any one know what king of pertition it's looking for and how do I make?

[davo]

you need to enable the debug options on the firmware updater and select "Rebuild partition table"

[jwlove59]

Ok, I openend up the firmware updated, right clicked on the title bar, and got the following 3 option, move,  close or version,  there was no debug option for me to choose.  So what is my next option?

[davo]

you need to enable the debug options first. Check FAQ 2 of 5 in the storage section on how to do this.