Red light on Linkstation Quad

[bouklyloo]

   

Hi,

I recently bought a Linkstation Quad and I have had a few problems when turning it on. My firmware is up to date and I am running Mac OS X leopard.

1) When I turn on the machine sometimes the LED light starts to blink red, I have read a bit about it and I learnt that it was a RAID error. How do I fix it (my firmware IS up do date)??

2) Sometimes when I turn on the machine, it starts to work properly but after around 6-7 hours some of the hard drives start to fail (some disk LEDs turn red). How do I fix this?

Thanks

[kevin]

Isnt this the same thread you created http://forums.buffalotech.com/buffalo/board/message?board.id=0101&thread.id=12119" target=_blank>here?

 

Please don't make more than one thread for one issue, as it clogs up our message board!

[bouklyloo]

   the second question is similar but the first is a new one.

[kevin]

All these issues will most likely be fixed by one solution as they are all probably cause by the same thing.

 

If this is infact a RAID issue, you will want to try deleting and re-building the array. Along with a RAID issue, it could be one or more faulty drives, in which case you will need to contact local support for replacements.