After Reset LinkStation to factory default values, navigator2 can't find it.

[J Miguel]

After Reset LinkStation to factory default values, navigator2 can't find it. Only 3 drives lightup in green the other drive is off (no light), and there is a red light flashing on the link station.

Before that I had a hard drive go bad and i replace it and started to rebuild the array, while the array was rebuilding other disk fail and i was not able to save the data. them i decided to reset to factory and start a new array. and did a Reset LinkStation to factory default values. If you can help me to be able to acces it with navigator2 and redo the array.
THANKS

Pardon my English,

Miguel

[WGBA]

You can try disabling your antivirus temporarily - then the NAS Navigator will find the NAS unit.

[absolutesavage]

You can also try enabling SMB version 2 or above on your buffalo product. Windows has recently disabled SMB version 1 that most units use by default.