Can't set volumes?

[dsmithwc04]

I am trying to setup the hard drives on my LS-WCL2BE.

 

When trying to create a folder it shows nothing in the hard drive volumes.  I can't figure out how to set up/ map the hard drive volumes.  I went to webacces/system/storage and it shows both hard drives but the format and check buttons are greyed out.  Also, under system info it shows the following..... Storage: Not available.

[davo]

post a screen shot of the system/storage/Array1 section. Does it show Array1(EDP)?

 

[dsmithwc04]

I haven't enabled the raid 1 edp.  I want to use raid 0 so I get full 2TB

[davo]

davo wrote:

post a screen shot of the system/storage/Array1 section.

 

 

 

[dsmithwc04]

http://s695.beta.photobucket.com/user/dsmithwc04/media/buffaloscreenshot_zpsa64011ce.png.html#/user/dsmithwc04/media/buffaloscreenshot_zpsa64011ce.png.html?&_suid=135714047413808807073108228072">http://s695.beta.photobucket.com/user/dsmithwc04/media/buffaloscreenshot_zpsa64011ce.png.html#/user/dsmithwc04/media/buffaloscreenshot_zpsa64011ce.png.html?&_suid=135714047413808807073108228072

[davo]

OK so, follow FAQ 2 of 5 to do a full debug (including rebuild partition table) once you do this the unit will start flashing 6 times (e06) once it does this follow FAQ 3 of 5 to reload the boot image.

[dsmithwc04]

Okay, attempted faq 2 of 5 and checked all the check marks even "rebuild partition table" and "Delete user-config".

 

ini file looks like this:

 

[Application] Title = BUFFALO LinkStation Series Updater Ver.1.64

WaitReboot = 1200

WaitFormat = 600

WaitFileSend = 600

WaitDiscover = 120

 

[Target]

ProductID = 0x00003006

ProductID2 = 0x00003007

ProductID3 = 0x00000016

ProductID4 = 0x00003008

ProductID5 = 0x00004001

ProductID6 = 0x00000017

ProductID7 = 0x00000019

Name = LinkStation

 

[Flags]

VersionCheck = 0

 

[SpecialFlags]

Debug = 1

NoFormatting = 0

 

Once, completed dialog box stated unable to format properly.

 

NAS is currently in EM Mode.

 

I went ahead and attempted faq 3 of 5 but never could get it to communicate with the tftp boot recovery exe.  Just kept saying it was "accepting requests..."

 

I did put the static IP to 192.168.11.1 like it said.

 

[dsmithwc04]

Still no luck...

[dsmithwc04]

Looks like this is going back to the store.  If I can't even get it to work out of the box how can I hope to keep it working...