HS-DHTGL boots up in EM mode.

[OPiz]

Hi. I have just bought a used HS-DHTGL/R5 server, but whenever I boot it up, it is going into HS-DHTGL-EMFD8(?) -mode.
I have tried resetting it, with the button under the display, but same thing occours.
This resulting that I cannot install any firmware, even tho I am availible to access via. TFTP bootrecovery tools.
But whenever I try to use the hs-dhtgl-up_214_102-updater, with Debug enabled and a force update, it keeps telling me ACP_STATE_FAILURE.
Both discs are newly formatted, and hold no bootrecord.

I try using the acp_commander with following arguments: -t IP -cb; to clean an eventually boot, giving me this output:

Using target: 192.168.11.150/192.168.11.150
Starting authentication procedure...
Sending Discover packet...
Found: HS-DHTGL-EMFD8 (/192.168.11.150) HS-DHTGL/R5(ANNEI) (ID=00326)
mac: 00:16:01:BB:0F:D8 Firmware= 6.00 Key=688B3C1D
Trying to authenticate EnOneCmd... ACP_STATE_OK
Sending clear /boot command sequence... OK (ACP_STATE_OK)
Output of df for verification... Filesystem 1k-blocks Used
Available Use% Mounted on
/dev/root.old 13303 12655 648 95% /
/dev/ram1 15360 48 15312 0% /mnt/ram

-

Could anyone be helpfull on this subject, if any knowledge? Thanks in advance!
If any further information is needed, i will do my best http://forum.buffalo.nas-central.org/images/smilies/icon_e_smile.gif" border="0" alt=":-)">

/Opiz

[davo]

Should it not be "Java -jar acp-commander.java -cb -t IP" ?

[OPiz]

Thanks for stating that out, but it did not work anyways.. I still get the ACP_STATE_FAILURE whenever I try to run the TSupdater.