Terastation RAID array dead?

[rwalker1]

   

I have a Buffalo Terastation HD-H1.0TGL/R5. Today I noticed it was not visinle on the network. The NAS navigaqtior could not find it. It was showing full on the status lights. I was able to use the web browser to access it. It said there was an error and it could not access disc 1. I shut it down and when I turned it back on I get a constant blinking red lighton the upper left staus/full light. There is no pattern. I am guessing one of the drives (drive 1 I assume) has died. Does that sound correct? If I remove that drive and replace it with the same size drive will the RAID array rebuild itself? I had it set on RAID 5. Other thoughts? Thanks.

[JoshC]

Once you replace the HD you have to go into disk management and check the box for the drive you replaced then click "rebuild raid array".

[rwalker1]

   

Thanks. I just replaced the drive and restructured the array. All data preserved and functionong normally again.