LS220D - Mapping Problem

[richard_uk]

Hi.

I have recently upgraded our NAS fearing our old LS-WVL/R1 unit is failing.

Like others have reported, I had a problem initially with getting NAS Nav 2 to see the new unit and then getting it to map.  After much messing about with various settings I am now at the stage where I have managed to map it on my PC and laptop but no matter what I do it will not map on my wife's PC.  I get the infamous "Error : Create a folder named "Share" before mapping the drive" problem.

Both PC's are running Windows 10 Pro (64 bit), both have SMB and SMB2 enabled, both are connected via ethernet and I have made sure that all network settings are the same as far as I can (different cards with slightly different options).  I have tried using wirless on my wife's PC to connect in case it was something to do with the network card but still no joy.

I am a total loss as to what to do next.  Any suggestions would be most welcome.

Thank you in advance.

Richard

[oxygen8]

do you use o&o shutup?

point 2 from

https://forum.nas-hilfe.de/buffalo-technology-nas-anleitungen/mit-windows-10-auf-ein-nas-zugreifen-t2736.html

[richard_uk]

Thanks Oxygen.  I have not used O&O Shutup before but have downlaoded it now.

I just need to figure out which is the crucial setting to get the LS220D mapped on the final PC.

[oxygen8]

Do not disable NCSI