LS-CHL - System time not saved

[matthestar]

   I have the Ls-CHL 1TB, 1.02. I am using the NTP server to set the time, which works great. However if you power down the device and switch off the power supply,you have to manually reset the time when you power on again. If the NTP server is set then surely it should synchronise the time upon power up?

[Paul]

I will test this then send up the request to get this resolved with the next firmware.

 

Thanks

[jacksp]

   

I have excactly same problem with LS-CHL 1TB but using already firmware 1.07.

If power supply was switched off you have to reset time manually after power supply is on and device is active although NTP server address is defined and working.

 

Are there any news / solution concerning this issue meanwhile?

Tx for support