LS-CHL V2 firmware problems

[coops74]

First some good news.....I've finally been able to get my devices to boot via the TFTP process using a 1.41 Kirkwood TFTP file set.

 

All looks well and she comes out of EM mode happily and presents correctly on NASNavigator2.  I've logged on to the web console and once I reset the language was able to set everything up as it was before the power cut.

 

Only one problem......every time I reboot the NAS, it returns to 6 flashing reds indicating a firmware issue.

 

If I repeat the TFTP process, all is well.  If I reflash the firmware, I go back to 3 flashing reds (raid error - on a single disk!!!) which was original problem after the power failure.

 

As it stands, I'm tempted to leave it as it is and use the TFTP process if I ever need to reboot.

 

Any other ideas????

[davo]

When it goes into EM mode try doing a full debug of the firmware (including rebuild partition table) and see how you get on. If that fails then you might be looking at a doggy HDD.

[coops74]

Tried it and failed...... Disk appeared ok when I took it out and mounted in my PC. I just tried another disk to confirm things and that is just the same.

[Corwin]

Hi Coops

did you ever get a solution for this problem.

I'm interested because i have the same problem after update.

 

Corwin