Can't install LS-WX2.0TL/R1

[stuckinatl]

I have two problems, I believe.  My Linkstation does not appear in the DHCP table of my router, and I also just changed computers to new Windows 7 64 bit, and cannot be any software to load. I downloaded the disk image LS-WXL300WR-DLS but it fails witth a NASA Navigtor2 error message of "Failed to read NASNaviPreference.xml."  I tried to find that file on the CD image but was only able to locate a file with the extension ".xml_"   I have seen other posts that talk abut a usb drive with software, but my unit appears to be older and did not come with one.  

1. How can I get the router to recognize the LinkStation and assign an IP address?

2. Am I trying to install the right program?  Do I need somewhere to find the ".wml" file instead of the ".xml_" file?

Thanks for any help.

[realborat]

Ok Reset first, 

LinkStation - LS-GL, HS-DHGL or LS-WTGL/R1 Ver.1

1. Look for the Init button on back of device.
   
2. Press and hold the red button for 10 seconds. The device will start beeping (no beep for LS-W TGL/R1).
   The password and IP address has been changed to default.
   

 

LinkStation - with a function (Func) button

1. Move the power switch to OFF and let the unit power down.
   
2. Then move the power switch to On while press and holding the Function Button. The Function LED will begin to flash blue for a minute.
   
3. While the Function LED is Flashing, push the Function Button again to begin the initialization process. All settings have been changed to default.

Make sure you have the Firewall and Antivirus software disabled on your pc when you are installing nas navigator

Also let us know if there are any led lights are flashing and what sequence/