First some good news.....I've finally been able to get my devices to boot via the TFTP process using a 1.41 Kirkwood TFTP file set.
All looks well and she comes out of EM mode happily and presents correctly on NASNavigator2. I've logged on to the web console and once I reset the language was able to set everything up as it was before the power cut.
Only one problem......every time I reboot the NAS, it returns to 6 flashing reds indicating a firmware issue.
If I repeat the TFTP process, all is well. If I reflash the firmware, I go back to 3 flashing reds (raid error - on a single disk!!!) which was original problem after the power failure.
As it stands, I'm tempted to leave it as it is and use the TFTP process if I ever need to reboot.
Any other ideas????
When it goes into EM mode try doing a full debug of the firmware (including rebuild partition table) and see how you get on. If that fails then you might be looking at a doggy HDD.
Hi Coops
did you ever get a solution for this problem.
I'm interested because i have the same problem after update.
Corwin