Buffalo Forums

I have model LS-CH1.0TL-US that I need to run the TFTP Boot procedure on.  Which version of the firmware (1.12 or 1.54) is needed for this model?

If your model  number is printed on the unit on the bottom in white, then it is the 1.54, if it is not, then it is 1.12

I have a quick question, Ive actually been trying to solve my problem in another part of the forum. I was reading in the TFTP readme that if my 
LS-CH1.0TL-US is black its a V2 and if its gray its a V1. Is this true?

not necessarily, post a picture of the bottom of your unit and ill tell you if its a V1 or V2

This is my first time on here I have no idea how to post an image?



Press this button and browse for the picture you have taken.

yea i dont have that button

Does "printed on the bottom in white", does that mean printed on a white label in black letters?

sPk

The bottom of my drive is as follows:

Front Foot - Black Label w/ Model:LS-CH1.0TL (printed in white)

Arch between front and back foot - Long white label with serial # below barcode on left and LS-CH1.0TL-US on right  (printed in black)

Back Foot - Black label w/voltage caution and some chinese jiberish I cant read (printed in white)

Mine is not up and running yet. Here's a picture of the bottom.

View photo

Can you tell which version I have from this?

I have the same sticker with the same model number, (LS-CH1.0TL-US). I'm at FW version 1.07....Did you find out which firmware version is the correct one?

Edit: I just grabbed the 1.12 version, and it successfully installed.

Take a look at the bottom of your LS  You will see CE letters on one side, if there is aLs Model number underneath, Yours is V2 and Fw version 1.54 or newer. But, I suspect yours is V1 and Fw version wil be 1.12

Yeah, mine is really old. But it did outlast a few other network backup drives! Anyway, I ran the 1.12 updater and it worked.

By the way, any idea where are the release notes for 1.12? I'd like to see what has changed since 1.07

---

Soylent wrote:

Yeah, mine is really old. But it did outlast a few other network backup drives! Anyway, I ran the 1.12 updater and it worked.

 

By the way, any idea where are the release notes for 1.12? I'd like to see what has changed since 1.07

---

Release notes:

http://www.buffalo-technology.com/en/download_file.php?r=7995