Buffalo Forums

   

running the above app on my gateway laptop with a wireless g connection and it is very flacky.  sometimes i get some of my nas devices show up, then they go away.  If i have two devices showing up, i hit refresh hoping i will get all 5 of my Buffalo devices to show up, but then i lose the two that was orginally up on the list.  Product works fine when i am hard wired.  But wireless, no joy. Any ideas.  Thanks in advanced.

Try changing channels on the router, and disable any frame bursting on both the PC and the router. 

   I changed the channel.  my access point doesn't have any options for Jumbo frames.  It seems to be a little better.  I will run it like this for a while and see how it goes.  Thank you.

   

Just wanted to give you an update. I have a total of 5 Buffalo NAS Devices.  Changing the channel seems to be helping.  I noticed that out of the five devices I am using, my HD-HGLAN Series devices seems to drop off the the NASNavigator2.

 

HD-HGLAN Series        

LS-320GL

LS-500GL

LS-W1.0TGL/R1-V3

LS-W1.0TGL/R1-V3

Make sure your running the latest firmware, then set the unit back to factory defaults from the web interface (this will not cause any data loss).

 

 

   

I don't think it's the Nas per se - I have it attached to my network.  All computers and devices that have wired connections see it and can access sharesreliably.  Anything connected wirelessly can rarely reliably access the shares.  Changing the channel hasn't helped here.  Still very unreliable for wireless devices.