6TB Link Station
LS-QLFD1
Model: LS-Q6.0TL/R5
Firmware ver: 1.11
NAS Navigator ver. 2.22
Rear power switch set to "ON"
I have my 1st power management option set to days; Mon. Tue. Wed. Thu. & Fri. On time: 0800
Off time: 1800. It did seem to work when I first set up the power management option. I noticed
that when I manually turned on the LS after 1800 to use it and then manually turned it back off,
it did not automatically turn back on the next morning at 0800. I then manually turned it on
around 0900 but it did not turn off at 1800. I tried to go back into the power management setting
and reselecting everything and clicking on 'Apply' again. It still didn't turn back on the next
morning at 0800. Ideally I would like to have the LS turn on every weekday for access while I'm
at work. If I need to use it in the evening, I would like to be able to turn it on briefly and then back
off without it affecting the 0800 scheduled turn-on time. Providing I can get this to work, it would
be nice if I could program just an 'Off' time, say 1 or 2 am in case I forgot to turn it off. The
minimal difference between 'On' & 'Off' time is 15 minutes. At one point I had a 2nd option set
up to turn 'On' the LS at 0100 and then 'Off' at 0115 but have disabled the 2nd time period since
I can not get my primary one to even work reliably. Any suggestions on how to set this up?