Linkstation Pro Duo
LS-W1.0TGL/R1-US
Workgroup: Workgroup
IP Address: 192.168.1.107
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.1
FIrmware: 3.09
I recently had my linkstation stop working. After slaving each drive one at a time, I found that neither the bios or windows on two seperate computers would recognize one of the drives. While one of the drives seemed to be entact, I was able to copy all my data off of it.
One of the drives was not working, so I purchased a new 500GB hard drive with the same model # and replaced it.
Following the directions from the top of the forum I have:
I booted it into EM.
I tried upgrading the firmware.
I tried forcing an update of the firmware.
At this point I was able to get to the web admin, in which I clicked the button to restructure the raid array. That was last night.
Today it is still not working. I can barely do anything in the web admin, it is very slow.
The red light is blinking on one long time, then 3 short times.
What should I try next?
After a while I'm able to get it in NASNavigator and this information is there:
Error:
E13:Error has occurred at RAID array 1. (2009/10/30 21:55:31)
information:
I255:An unknown error occurred. (2009/10/30 21:56:58)
I can make it to Disk Management in the admin:
It sounds like it's trying to rebuild the raid array. Could take around a day for that to happen.