I have a TS-RHTGL/R5 F/W 1.33 (Rackmount) - "The Source"
where I am creating a backup job to copy to an earlier Terastation with firmware 2.14 - "The Destination"
I can specify the Backup Password on the Destination terastation. (In Shared Folders).
However when creating the Backup Job in the Source, there seems to be no place to enter the password under Disk Backup. According to HELP, there should be a field called:
"
Backup Destination Shared Folder Password
Enter the password of the destination backup shared folder (if required).
"
This seems to be missing from Disk Backup. Is the firmware bugged?
I note that at the end of the "Disk Backup" page is
"
Search for a Backup Destination by Password
"
followed by a button strangely worded APPLY rather than SEARCH. Once APPLY is clicked, the screen refreshes and says at the top "Settings saved".
Is this where to set a disk backup password and is the UI wrongly worded? If so, does this mean that all the backup jobs have to use the same password?
This is quite confusing :(
I'm a bit surprised there doesn't seem to be an easy answer to this question and the UI may be wrong. I have tested and it seems I can "set" the backup password using the "Search" function. This would however leave me with only one password per Source terastation which would mean all Backup terastations would need the same password.
I am new to this type of hardware and have no idea what the support is like. Should I submit this Q to support?
Thanks for any suggestions