Buffalo Forums

Hi

New to the forum

Have a LS 250 which I have had for over a year.Only used occasionally as a backup for our home PC's

Always worked well - switched on yesterday couldn't access it although there was an IP address allocated by the router and couldn't acces the interface.

Tried again today - still the same - noticed that it had gone into EM mode 

Downloaded firmware updater - allowed to update (I have updated loads of firmaware and never had a failure until now)this failed - now the Linkstation just beeps and flashes error continuously.The updater says thre is no drive to update

Tried using reset but no different 

Have I lost all my backups ? Is it dead ? Any help is greatly appreciated.

Hi

I just seen your thread a bout the buffalo LS and i have just got a LS-250GL and immediately 4 error flahes and saw the fan not working

have tried to get the fan out but cant, i have the side off and hard drive out but how did you get the fan out after that bit

would really appreciate your knowledge on how you done it

thanks

steve

Hi Steve

never did get the Linkstation to work again - Buffalo tech never sent a RMA as promised so I dismantled it and fitted a new fan - still wouldn't work.

In the end I removed the hard drive then copied all the software to my PC - this took a long time and you need to have a knowledge of Linux

I like Buffalo stuff but this was a real letdown and support was really poor in my case

Getting the fan out is abit difficult. BEst thing is to remove the back plastic plate follow by the unscrewing of the two screws tighten the metal cast to the side plate.

Have you tried using abit of WD40 on the fan?

I've tried it couple of times and it started spinning.

But sometimes might not be the fan. I've experienced changing the fan but to same problems.

So what i did was solving it by TFTP and it worked!