Print Page - Trouble setting up Web Access - LinkStation Pro LS-XH2.0TL

Title: Trouble setting up Web Access - LinkStation Pro LS-XH2.0TL
Post by: sftrny on August 31, 2009, 02:28:13 PM

I am using a Link Station Pro LS-XH2.0TL.

Firmware has been upgraded to 1.10.

LS is connected to a Linksys router BEFSR81.

LS is assigned a static IP (192.168.1.99).

I am not using HTTPS.

I am using BuffaloNAS.com

BuffaloNAS name and key are specified.

Auto Configure of firewall returned error, so I manually set external port to 9000.

In the router setup for UPnP Forwarding, for both TCP and UDP traffic, I have set external port 9000 to forward to the LS IP Address and Port 9000. DMZ is off.

I can get to web access from inside my network, but not from outside the network? Any suggestions?

Title: Re: Trouble setting up Web Access - LinkStation Pro LS-XH2.0TL
Post by: PCPiranha on August 31, 2009, 03:56:50 PM

The only reason for that would be firewalls. Do you have DSL or cable internet? What is the model of your modem? Does canyouseeme.org see the ports as open?

Title: Re: Trouble setting up Web Access - LinkStation Pro LS-XH2.0TL
Post by: sftrny on August 31, 2009, 04:14:57 PM

I don't have cable or DSL. I have a fiber connection to my house (bundled services in a planned housing community). I checked with my ISP and they said that port 9000 is not blocked on their end. When I try canyouseeme.org, it says "connection timed out". So I am guessing that the my router is blocking it? Is there a way to check to see where the blockage is?

Title: Re: Trouble setting up Web Access - LinkStation Pro LS-XH2.0TL
Post by: PCPiranha on August 31, 2009, 04:20:36 PM

Most likely the port is not properly forwarded in the router.

Buffalo Forums

Products => Storage => Topic started by: sftrny on August 31, 2009, 02:28:13 PM