Buffalo Forums

Please help.

Just bought linkstation quad 1.0TB included yesterday. Firmware version 1.11.

Running XP and VISTA, all using IP 192.168.1.X

Linkstation was configured to use 192.168.1.188.

I was able to access the web admin via http://192.168.1.188 and the shared folders this morning.

Thanks in advance.

Opps sorry did not include the problem.

The problem is after power outage which happened on 30 Aug, I was unable to access the LinkStation. Unable to detect using NASNavigator nor access the webadmin using 192.168.1.188.

When I switch on the NAS, the power LED shows 6 red flash. According to the forum it says the harddisk is faulty. I bought the LinkStation Quad (comes with 1TB HDD) on 29 Aug. Therefore I don't think the harddisk spoil so easily, do they?

Please advice. What should I do now? Buy a new harddisk and replace it?

Thanks in advance.

After reading this solved thread,

http://forums.buffalotech.com/buffalo/board/message?board.id=SolvedStorageThreads&thread.id=2606

I did place an 1TB WD into the 2nd slot and configured raid 1 on them. Everything was running fine until the power outage, the 6 red flash begin to appear when i boot up the system.

Although the 6 red flash is appearing, I am unable to access the web admin page to view the problem. I removed the 2nd HDD and leave the original HDD that comes with the linkstation the problem still persist.

I remove all HDD and boot up the 6 red flash still there and unable to access the web admin.

No matter what I try I was unable access the web admin page.

Please adviace. Thanks in advance.