Buffalo Forums

Products => Storage => Topic started by: smace@chathamhospital.org on September 12, 2014, 12:46:10 PM

Title: Terastation TS-RVHL RAID6, 2 drives failed.... not sure if it is rebuilding.
Post by: smace@chathamhospital.org on September 12, 2014, 12:46:10 PM
I have a Terastation TS-RVHL, 4 3TB drives, set up as RAID 6.

Today, two drives failed (1 and 3).  It instructed me to replace both drives, which I did with Buffalo replacements.

I followed the replacement instructions, and when the red LEDs changed to blinking for both drive 1 and 3, I pressed the function button until it beeped.

Drive 3 is now "green" on the front panel, drive 1 is still blinking red, the display is prompting me to push the function button again, but it does not respond.

If I attempt to log in via the web interface, I get a message:
"Changing RAID Array...
Cannot change all of the configurations until changing Raid Array is completed. Also share folder service is not working.
Details
Progress: 10 %"

It has been here for over an hour. Before I replaced the drives, I could access the shares; now I cannot.

Is this expected behavior?  Should I have only replaced one drive at a time?
Browser ID: smf (is_webkit)
Templates: 1: Printpage (default).
Sub templates: 4: init, print_above, main, print_below.
Language files: 1: index+Modifications.english (default).
Style sheets: 0: .
Hooks called: 45 (show)
Files included: 27 - 1055KB. (show)
Memory used: 734KB.
Tokens: post-login.
Queries used: 10.

[Show Queries]