Buffalo Forums

We have a TS-WXL that will occasionally shut down. It's plugged into a UPS and has good ventilation.

Here's a snippet from the logs around the time of the shut down...

I don't see anything except maybe the final entry saying disk 1 not found.

Jun 14 22:04:07 TPI-TS2 S40B_update_notifications.sh: notifing lcd...
Jun 15 05:24:52 TPI-TS2 kernelmon: cmd=micon_interrupts
Jun 15 05:24:52 TPI-TS2 linkstation: SHUTDOWN START normal
Jun 15 09:14:59 TPI-TS2 u-boot: BUFFALO U-BOOT Start !!! 
Jun 15 09:14:59 TPI-TS2 u-boot:  ** LOADER **
Jun 15 09:14:59 TPI-TS2 u-boot:  ** BUFFALO BOARD: DB-MV78100-A-BP LE (CFG_ENV_ADDR=fff80000)
Jun 15 09:14:59 TPI-TS2 u-boot: U-Boot 1.1.4 (Jun  7 2012 - 21:18:04) Marvell version: 3.3.5
Jun 15 09:14:59 TPI-TS2 u-boot: Buffalo Version: 2.10-1.01
Jun 15 09:14:59 TPI-TS2 u-boot: U-Boot code: 00600000 -> 0066FFF0  BSS: -> 00684D30
Jun 15 09:14:59 TPI-TS2 u-boot: Soc: MV78100 A0 (DDR2)
Jun 15 09:14:59 TPI-TS2 u-boot: CPU running @ 800Mhz L2 running @ 266Mhz
Jun 15 09:14:59 TPI-TS2 u-boot: SysClock = 400Mhz , TClock = 166Mhz 
Jun 15 09:14:59 TPI-TS2 u-boot: DRAM CAS Latency = 5 tRP = 5 tRAS = 19 tRCD=5
Jun 15 09:14:59 TPI-TS2 u-boot: DRAM CS[0] base 0x00000000   size 512MB 
Jun 15 09:14:59 TPI-TS2 u-boot: DRAM Total size 512MB  64bit width
Jun 15 09:14:59 TPI-TS2 u-boot: [512kB@fff80000] Flash: 512 kB
Jun 15 09:14:59 TPI-TS2 u-boot: Addresses 8M - 0M are saved for the U-Boot usage.
Jun 15 09:14:59 TPI-TS2 u-boot: Mem malloc Initialization (8M - 7M): Done
Jun 15 09:14:59 TPI-TS2 u-boot: NAND:512 MB
Jun 15 09:14:59 TPI-TS2 u-boot: CPU 0: ARM926 (Rev 0)
Jun 15 09:14:59 TPI-TS2 u-boot: Streaming enabled 
Jun 15 09:14:59 TPI-TS2 u-boot: Write allocate disabled
Jun 15 09:14:59 TPI-TS2 u-boot: FPU initialized to Run Fast Mode.
Jun 15 09:14:59 TPI-TS2 u-boot: enaDCPref <NULL>
Jun 15 09:14:59 TPI-TS2 u-boot: enaICPref <NULL>
Jun 15 09:14:59 TPI-TS2 u-boot: setL2CacheWT no
Jun 15 09:14:59 TPI-TS2 u-boot: setL2Size256K no
Jun 15 09:14:59 TPI-TS2 u-boot: disL2Ecc no
Jun 15 09:14:59 TPI-TS2 u-boot: disL2Prefetch yes
Jun 15 09:14:59 TPI-TS2 u-boot: disL2Cache no
Jun 15 09:14:59 TPI-TS2 u-boot: env finished
Jun 15 09:14:59 TPI-TS2 u-boot: USB 0: host mode
Jun 15 09:14:59 TPI-TS2 u-boot: USB 1: host mode
Jun 15 09:14:59 TPI-TS2 u-boot: USB 2: host mode
Jun 15 09:14:59 TPI-TS2 u-boot: PEX 0: interface detected no Link.
Jun 15 09:14:59 TPI-TS2 u-boot: PEX 4: interface detected no Link.
Jun 15 09:14:59 TPI-TS2 u-boot: Net:   egiga0 [PRIME], egiga1
Jun 15 09:14:59 TPI-TS2 u-boot: buffalo_change_power_status > Read 0x71(normal_state)
Jun 15 09:14:59 TPI-TS2 u-boot: buffalo_change_power_status > Writing 0x5c(swpoff_uboot_passed)
Jun 15 09:14:59 TPI-TS2 u-boot: Marvell Serial ATA Adapter
Jun 15 09:14:59 TPI-TS2 u-boot: Integrated Sata device found
Jun 15 09:14:59 TPI-TS2 u-boot: [0 0 0]: Enable DMA mode
Jun 15 09:14:59 TPI-TS2 u-boot:   Device 0 @ 0 0:
Jun 15 09:14:59 TPI-TS2 u-boot: Model: Hitachi HDS722020ALA330                  Firm: JKAOA28A Ser#:       JK1170YAHD95KP
Jun 15 09:14:59 TPI-TS2 u-boot:             Type: Hard Disk
Jun 15 09:14:59 TPI-TS2 u-boot:             Supports 48-bit addressing
Jun 15 09:14:59 TPI-TS2 u-boot:             Capacity: 1907729.0 MB = 1863.0 GB (-387938128 x 512)
Jun 15 09:14:59 TPI-TS2 u-boot: [0 1 0]: Enable DMA mode
Jun 15 09:14:59 TPI-TS2 u-boot:   Device 1 @ 0 1:
Jun 15 09:14:59 TPI-TS2 u-boot: Model: Hitachi HDS722020ALA330                  Firm: JKAOA28A Ser#:       JK1130YAHDG77T
Jun 15 09:14:59 TPI-TS2 u-boot:             Type: Hard Disk
Jun 15 09:14:59 TPI-TS2 u-boot:             Supports 48-bit addressing
Jun 15 09:14:59 TPI-TS2 u-boot:             Capacity: 1907729.0 MB = 1863.0 GB (-387938128 x 512)
Jun 15 09:14:59 TPI-TS2 u-boot: MAC Address on eth0  : 00:1d:73:e7:5d:77
Jun 15 09:14:59 TPI-TS2 u-boot: Signature version    : 1.00
Jun 15 09:14:59 TPI-TS2 u-boot: Signature MACAddress : 00:1d:73:e7:5d:77
Jun 15 09:14:59 TPI-TS2 u-boot: 2826048 bytes read
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Name:   Linux-2.6.31.8-mv78100
Jun 15 09:14:59 TPI-TS2 u-boot:    Created:      2012-07-11  23:44:03 UTC
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Type:   ARM Linux Kernel Image (uncompressed)
Jun 15 09:14:59 TPI-TS2 u-boot:    Data Size:    2825984 Bytes =  2.7 MB
Jun 15 09:14:59 TPI-TS2 u-boot:    Load Address: 00008000
Jun 15 09:14:59 TPI-TS2 u-boot:    Entry Point:  00008000
Jun 15 09:14:59 TPI-TS2 u-boot: 9181907 bytes read
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Name:   initrd
Jun 15 09:14:59 TPI-TS2 u-boot:    Created:      2012-07-11  23:46:32 UTC
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Type:   ARM Linux RAMDisk Image (gzip compressed)
Jun 15 09:14:59 TPI-TS2 u-boot:    Data Size:    9181843 Bytes =  8.8 MB
Jun 15 09:14:59 TPI-TS2 u-boot:    Load Address: 00000000
Jun 15 09:14:59 TPI-TS2 u-boot:    Entry Point:  00000000
Jun 15 09:14:59 TPI-TS2 u-boot: Signature version    : 1.00
Jun 15 09:14:59 TPI-TS2 u-boot: Signature MACAddress : 00:1d:73:e7:5d:77
Jun 15 09:14:59 TPI-TS2 u-boot: 2826048 bytes read
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Name:   Linux-2.6.31.8-mv78100
Jun 15 09:14:59 TPI-TS2 u-boot:    Created:      2012-07-11  23:44:03 UTC
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Type:   ARM Linux Kernel Image (uncompressed)
Jun 15 09:14:59 TPI-TS2 u-boot:    Data Size:    2825984 Bytes =  2.7 MB
Jun 15 09:14:59 TPI-TS2 u-boot:    Load Address: 00008000
Jun 15 09:14:59 TPI-TS2 u-boot:    Entry Point:  00008000
Jun 15 09:14:59 TPI-TS2 u-boot: 9181907 bytes read
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Name:   initrd
Jun 15 09:14:59 TPI-TS2 u-boot:    Created:      2012-07-11  23:46:32 UTC
Jun 15 09:14:59 TPI-TS2 u-boot:    Image Type:   ARM Linux RAMDisk Image (gzip compressed)
Jun 15 09:14:59 TPI-TS2 u-boot:    Data Size:    9181843 Bytes =  8.8 MB
Jun 15 09:14:59 TPI-TS2 u-boot:    Load Address: 00000000
Jun 15 09:14:59 TPI-TS2 u-boot:    Entry Point:  00000000
Jun 15 09:14:59 TPI-TS2 u-boot: ** Something is wrong, because of dev_desc->blksz is 0!!!
Jun 15 09:14:59 TPI-TS2 u-boot: disk2 is not found!
Jun 15 09:14:59 TPI-TS2 u-boot: ** Something is wrong, because of dev_desc->blksz is 0!!!
Jun 15 09:14:59 TPI-TS2 u-boot: disk3 is not found!

Under System > Storage > At the bottom of the page

'Raid Array Error Detection Response'

What is that set to?