Buffalo Forums

Hi , ive bought a CS-X2.0 in march , nobody can give me a right support from buffalo, when ive power on after 10 mins the blue led stop flashing and gets solid blue color.

then i open the nas navigator, and i see it in EM mode with the automatic assigned ip address, in firmware section, say --- .

then ive download the lastest firmware from the buffalo site --> http://buffalo.jp/support_ap/support/pr ... _wv_x.html

ive enabled the debug option in the ini file, same thing if ive select format , erase user data, or no mather which option ive select i get always the same error ACP_STATE_FAILURE.

ive tryed the same procedure with the nas connected directly to my nic card , in win xp or 7 , without firewall , and always get the same error ACP_STATE_FAILURE.

i dont know if this model supports ssh, tftp, ive tried both without success.

this is a brand new unit, ive used 1 time , copyed 5 gb of data from my internal network .. .power off/on and then neever came back online.

ive tried also to read the drive from my pc , but noluck

also tried using 2 sata drives instead the original , no luck also, the blue led never came solid. ( there is a special procedure or something to use blanks hd ? )

the unit is in warranty , but there is no support in Argentina, also im not able to send the unit to MALASYA ( where ive bought )

ill appreciate any suggestion.


also ive posted http://forum.buffalo.nas-central.org/viewtopic.php?f=4&t=27057

regards

Sebas

anyone? i have a brand new black brick in my house ?

Hmm, EM mode will usually allow you to flash the firmware. Since it's an Asia-Pacific unit, try downloading the firmware from the Australian site and see how that works.

This is moderated by the US, I'm going to be of limited help inter-regionally.

ill bought the same seagate sata hard drive in order to replace it...

after that,,,

my unit start blinking and continue doing that ...

any help?

regards

Use acp commander to clear the acp stat failure error.