Buffalo Forums

Hi

Howcome i just can transfer data to my LS-CHL with about 2800kbps over a 1000Mbps wired network, with Jumboframe support, I am connecting my pc to my LS-CHL using a Buffalo WZR-AG300NH, is there any settings i need to change on the LS-CHL or on the Router?

Best Regards

Morten

The original 1,518-byte MTU for Ethernet was used because of the high error rates and low speed ofcommunications. Thus, if one receives a corrupted packet, only 1,518bytes must be re-sent to correct the error. However, each framerequires that the network hardware and software process it. If theframe size is increased, the same amount of data can be transferredwith less effort. This reduces CPU utilization (mostly due to interruptreduction) and increases throughput by allowing the system toconcentrate on the data in the frames, instead of the frames around thedata. At the sender, a similar reduction in CPU utilization can beachieved by using TCP segmentation offloading,although this does not reduce the receiver CPU load.Interrupt-combining Ethernet chipsets, however, do provide most of thesame gain for the receiver, and work without special considerationwithout requiring all stations to support jumbo frames. Zero-copyNICs and device drivers, when combined with interrupt combining, canprovide effectively all the gains of jumbo frames without the re-sendcosts, and without requiring any changes to other stations on thenetwork.

  Whew, that's a read and a half. Anyway, long story short with jumboframes enabled on a low traffic high speed network you're actuallygoing to get a slower transfer speed. Jumbo frames work as a doubleedged sword in simple terms. When used incorrectly your transfer speed will drop at least that's what I've seen anyway. Try defaulting your ethernet frame size and see if that helps. :)

My apologies I just didn't know which version you had. My recommendation if you're still experiencing slow transfer speeds would be:

• Initialize the unit through the web user interface
• Check and make sure the ethernet cable you're using is substantial (if it's the cable that came with the device I would swap that out with a better shielded cable)

If you're still experiencing transfer issues I would recommend a force firmware update and then initialize the unit immediately after.

I use STP Cat 6E cable, and only 15 feet as the longest cables, i dont get any transfer speed improvement if i just connect my pc with a crossover cable directly to the Linkstation.

Will i loose data if i initialize the unit, or if i force a firmware update? because 500gb takes a long time to transfer back and fourth, with the current speed of the linkstation.

Is the LS-XHL faster than the LS-CHL?

Best Regards

Morten