Buffalo Forums

   

I reset my wireless router because I was having difficulty trying to connect to a VPN service. After hard resetting the router (mistake), I reset all of the router and PC settings to my previous settings and both of my laptops (windows XP & Vista 64 bit) can see the network name; try and connect, but after about 2 minutes it stops and fails. I have no problems connecting through the wired connection on the router. So, now I have two problems - not able to connect to VPN or wireless connection.

 

I need the VPN because I am on temporary assignment in China from the US and the Chinese government has blocked Youtube, most blogs, facebook, etc.

   Make sure DHCP is enabled in the router and has a large range(say for up to 64 addresses) and make sure the computers are set to obtain an IP automatically.

   Thanks for the tip. I will try when I get home from work tonight.

   Still no luck in getting wireless to connect after checking DHCP settings. I have the WHR G300N attached to a linksys router which is connected to a dsl cable modem. I unplugged all devices and waited 5 minutes, then started dsl modem, linksys router, and WHR G300N in that order -- still no wireless. I also tried to change the encryption from WPA to WEP. I did have all of these components working great for about 5 months before I tried to connect to a VPN service and rebooted by WHR G300N.

   Try changing the wireless channel and check that MAC Filtering is turned off.

   Thank-you sooooooooooo much! Changing the wireless channel worked. Now I have to figure out my VPN.

   You may need to tick PPTP Pass Through in the router (security>VPN Pass Through) for VPN to work.

   Thanks again for your help. It worked!