I have LS-500GL with gigabit. It was running firmware v1.11 and I tried to upgrade it to v.15 by downloading LS-GL_FW_115 file from the web site. I used LSUpdater and it found the device and started transferring the image file. It completed the transfer but gave an error message at the end. I rebooted the LS-500GL and it now cannot boot. It starts beeping with red error LED flashing 6 times. After a while it changes to 4 flashes and at that time HD turns off and power green LED goes off too, but red LED flashes 4 times. LS was connected to the laptop where I was running the LSUpdater.exe via wireless connection from my PC. What should I do now? Please help.
=======================================================
Update:
I connected LS-500GL and my PC on a separate ethernet switch.
I was able to fix the problem by following instructions at:
http://forums.buffalotech.com/buffalo/board/message?board.id=0101&message.id=881&query.id=26577#M881 and booting in the EM mode. After that I used LMUpdate.exe file with debug option (add section [SpecialFlags]
Debug = 1 to lsupdater.ini file) and right click on the program task bar to change the IP address to 192.168.11.3. Once the IP address was changed, updated the flash to v1.15. It came back to life and working fine now.
The lesson learned was not to update the FW over wireless network. Always connect it directly to LS-500GL or via switch.