Print Page - upgrade TS

Title: upgrade TS
Post by: selbendary on March 08, 2009, 10:32:15 AM

when we tried to upgrade TS-H01TGL/R5 to 4TB (4*1TB HDD) the system give us TFTP Mode E06 Lost boot image. how we can solve this.

We upgrade the TS because the 2 HDD 250GB installed in the system failed due to change of electricity

Title: Re: upgrade TS
Post by: JoshC on March 08, 2009, 10:29:52 PM

Selbendary,

when you did this did you take one drive out then replace the new one and restructure the raid array so on so forth with all four drives?

Title: Re: upgrade TS
Post by: selbendary on March 09, 2009, 05:26:09 AM

No the four drives replacment together because the old drive was faulty

Title: Re: upgrade TS
Post by: Dustrega on March 09, 2009, 04:56:01 PM

selbendary,

Then you would need to perform a TFTP boot through the instructions outlined here followed by a firmware update for your device. Keep us posted.

Title: Re: upgrade TS
Post by: selbendary on March 10, 2009, 04:26:36 AM

We did it but we can not access TS and navigator did not found Buffallo

No antivirous or firewalls running, we can not ping the unit?

Title: Re: upgrade TS
Post by: Colin137 on March 12, 2009, 04:10:27 PM

Try it again... this is the only method of getting the unit to work with four new drives. Try rebooting the TS once the TFTP software is running, and make sure your computer's IP address is 192.168.11.1, and the computer is connected to the same switch or router as the TS.

Buffalo Forums

Products => Storage => Topic started by: selbendary on March 08, 2009, 10:32:15 AM