Perhaps someone can help before i start calling tech support.
Currently i have a Sonos music system connected to my linkstation live unit.
This all worked fine until i came home from holiday to find my house electricity had been interrupted and my linkstation had as usual not powered up. I pressed the power on button and walked away only to hear a little time later an internment beeping. The power on light was flashing which i tried two or three times to recover the unit by powering down the unit which eventually worked.
My sonos system however reported it could not connect.
I tried to connect my laptop through the buffalo software which i have used before and i got no joy.
The buffalo software shows the correct ip but the workgroup area says unknown and the firmware is displayed with only four dashes.
If i try and access the unit using the i am here or try to modify anything the password which i had left as standard does not allow access.
I can ping the ip and get replies but all other attempts prove unsuccessful.
i tried deleating and reinstalling the buffalo software on my laptop with still no joy.
No fault LED's are lit but still this unit is playing dumb.
I would appreciate any info as what to do.
Cheers