Buffalo Forums

Hello,

I've setup a WHR-G300N as an AP on my network. I can't access the network (or the internet) from the wireless connection.

Laptop plugged into the AP switch and GW/Firewall works fine.

Wireless connection;

AP <==> Laptop        - OK (I can access the configuration page on the AP)

AP <==> GW/Firewall  - OK

** Laptop  <==> AP <==> GW/Firewall - No connection.

The default gateway is set in the AP (same address on the laptop). I've not setup any static routes on the AP.

Found the incorrect setting;

"Separate feature" - (Under Basic Wireless)

Connected wireless devices can communicate with WAN side devices if this setting is enabled.

It's opposite to this, I had to untick (disable) the option and save the settings, WAN side traffic started to flow.

Hi, i have WHR-G300N Ver.1.60 (R1.49/B1.09) and i have a problem.

My network provider not supporting DHCP, and i try manual settings, but there is only can type Gateway, Mask and DNS server. I do not know where can type my external IP adress.

Hi again, may be i can not explane right?

I dont know where i can change my static external IP.

It is possible?

It is provided by the service provider. 

Making the changes in the router will be on the WAN set up  page of the web interface. 

OK, I understand, but my WAN menu doesn't have any position for ext. IP

Here is the screenshot:

May be my Internet provider gives me some IP on DHCP, but I have payed for static one and I want to have it.