Print Page - "No Init File At HDD 3"

Title: "No Init File At HDD 3"
Post by: Aleksiv95 on May 03, 2013, 09:34:22 AM

Hi everyone!

I have a TeraStation ES 4TB model that shows "No Init File At HDD 3" on startup. The device doesn't show the error light and the message is only shown very briefly on startup, but I don't know what it means or if it's important or serious. Does anyone have any suggestions?

Aleksi

Title: Re: "No Init File At HDD 3"
Post by: DiC on November 12, 2017, 04:40:28 AM

Hi,
I have terastation 3400 with 4 disk in Raid 5 .
I switch off Nas (push 3 sec Power button) for change UPS
When i restanti It at startup Nas show "no init file at hdd 3"
I can't see Nas in my internet.
Help me!

Title: Re: "No Init File At HDD 3"
Post by: Eastmarch on November 13, 2017, 02:05:02 PM

Try booting the system with drive 3 out.

Title: Re: "No Init File At HDD 3"
Post by: DiC on November 13, 2017, 10:31:52 PM

in this state Nas not permit any action.
But yesterday it finish booting (never see on lan ) and display show info i41 code than i try recovery (push function button ) but it fail.
Now i contact assistance , operator tell me same soluction ,
turn off
ectract hdd3
restart
show this message
no init file at hhd 3
no init file at hhd 1
no init file at hhd 2
nand boot
error (red display )
try recovery but fail.
dislay now blue , firmware version not showed , no error led lamp , no lan parameter lost.
Assistance send me usb boot procedure for recovery , today i try i hope recover data !

Title: Re: "No Init File At HDD 3"
Post by: DiC on November 14, 2017, 09:31:34 AM

USB boot done but recovery failed !
Now try control any hdd
can suggest correct metod ?

i think put off one hdd,
with cristal disk app control by my win10 pc
it's correct ?

Buffalo Forums

Products => Storage => Topic started by: Aleksiv95 on May 03, 2013, 09:34:22 AM