Print Page - Check Disc 4tb Linkstation

Title: Check Disc 4tb Linkstation
Post by: stevecrt on March 03, 2013, 01:24:33 PM

I am performing my first disk check on a Raid 0 4Tb Linkstation Pro (Firmware 1.64) with over 2.5tb of data.

It was merely routine and not becuse of any fault.

It has now been over 28 hours and the I/O light is still flashing 1 Long 4 short.

Any suggestions as to how long this will take and is it possible to interupt the operation?

I have tried (as per another thread) to plug in a USB but it had no affect.

Thanks in advance.

Steve

Title: Re: Check Disc 4tb Linkstation
Post by: davo on March 03, 2013, 06:04:41 PM

Is the led red or orange?

Title: Re: Check Disc 4tb Linkstation
Post by: stevecrt on March 03, 2013, 06:19:37 PM

HI Davo
Thanks for the response. I have blessed with colour blindness.. It looks more green then orange but I don't think it's Red. Info/Error 1 long 4 short.
Sorry it's a bit vague.

Title: Re: Check Disc 4tb Linkstation
Post by: davo on March 04, 2013, 03:05:13 AM

OK so, in that case run the Nas Navigator software and it should let you know the exact error, bare in mind it might be E14 which means the RAID has collapsed :-(

Title: Re: Check Disc 4tb Linkstation
Post by: stevecrt on March 04, 2013, 03:17:21 AM

Nas Nav does not detect the drive. The UI and IP adreess in the browser does not access the drive either.

Buffalo Forums

Products => Storage => Topic started by: stevecrt on March 03, 2013, 01:24:33 PM