Print Page - Issues with Terastation

Title: Issues with Terastation
Post by: TITUS137 on February 03, 2009, 07:15:14 PM

I have a terastation and I could access it through my network. I moved my terastation 3 feet where I had to unplug the network cable and then plug it back in. Now I cannot access the unit. When I go to the NAS Navigator to it shows the IP address - does not show the drives . When I try to go to set up and browser management- it goes to the internet then comes back with a not found page. But my internet works fine otherwise on that computer.

I have the terastation hooked up through the network using a Linksys router. The linksys software shows the unit a part of the network .

I have rebooted both the computer and the terastation- now the terastation says operating in emergency mode. What should I try?

Title: Re: Issues with Terastation
Post by: kevin on February 04, 2009, 09:06:37 PM

First off:

-What is the Model?

-What OS are you using?

-Does the TS display any errors on the unit itself?

-What is the Firmware version you are running?

-Does the NAS Navi give you a FW version?

Try going to Start> Run> \\IP of the TS

Browser ID: smf (is_webkit)
Templates: 1: Printpage (default).
Sub templates: 4: init, print_above, main, print_below.
Language files: 1: index+Modifications.english (default).
Style sheets: 0: .
Hooks called: 50 (show)
Files included: 27 - 1055KB. (show)
Memory used: 734KB.
Tokens: post-login.
Queries used: 10.

[Show Queries]

Buffalo Forums

Products => Storage => Topic started by: TITUS137 on February 03, 2009, 07:15:14 PM