Print Page - Linkstation degraded Mode

Title: Linkstation degraded Mode
Post by: PaulThBrit on November 28, 2012, 08:16:47 PM

I successfully upgraded my Linkstation LS-WX1.0TL from 2 x 1TB drives to 2 x 3TB drives. The box worked well. Too well, so I decided to check if the data could be recovered with a failed drive. I powered down the box, pulled a drive and powered it back up. The box correctly identified a failed drive and illuminated the red light under the failed drive and flashed a 'I-12' code indicating it was operating in degraded mode. I checked I could access the data and all was well. I then powered down the box and plugged the drive back in.

The box is working normally, but the web interface shows Drive 1 (the one I had pulled) as 'Error'. The Code 'I-12' is still flashing. Does it take a while for the error to clear and the box to decide it doesn't need to operate in degraded mode, or is there a procedure to clear the error?

Thanks,

Paul

Title: Re: Linkstation degraded Mode
Post by: realborat on November 30, 2012, 06:48:12 AM

Log on to the web interface, go to System/storage, lower half of window you will see Raid array select the disk and rebuild RAID,

Browser ID: smf (is_webkit)
Templates: 1: Printpage (default).
Sub templates: 4: init, print_above, main, print_below.
Language files: 1: index+Modifications.english (default).
Style sheets: 0: .
Hooks called: 50 (show)
Files included: 27 - 1055KB. (show)
Memory used: 736KB.
Tokens: post-login.
Queries used: 10.

[Show Queries]

Buffalo Forums

Products => Storage => Topic started by: PaulThBrit on November 28, 2012, 08:16:47 PM