I've recently performed a Firmware flash on my HS-DHGL (after having HD issues - which sare now resolved) however, i'm having troubles connecting to the NAS. Using the Navi software, I set the IP Address to use DHCP.
Now, with the NAS plugged into the router, I switch it on, after a few seconds I see the NAS as an attached device on my router and the 'link' light (on the front panel of the NAS) flash. However, after another few seconds, the link light stops flashing and the IP address is released by the router?
Any ideas what this could be? I'm pretty sure its not the router as this is exactly the same config as it was before - and i've had no issues like this before.
Thanks