My LS-WTGL/R1-V3 F/W 3.05 is giving the following message: "Error has occurred in RAID Array1"
See here for a screenshot: http://img4.imageshack.us/img4/6621/diskmgmt1yg3.jpg
I am not sure what this means, the manual doesn't help. The checkbox for disk 1 is already checked and greyed out, so no changes are possible, and If I check the box for disk 2 and click "Restructure RAID array" it warns me that the data stored on the targed disks will be deleted. Don't want that...
See screenshot here: http://img26.imageshack.us/img26/9281/diskmgmt2ue0.jpg
Additionally:
1) The red LED on the front flashes 4 times, or at least that's what it seems like - one longer flas followed by three shorter flashes.
2) Accessing the NAS directly through the browser is spotty - after a short while (~60 sec) I get a network timeout error. Reloading immedietely after that I get a Failed to connect error, and then after some time (~60 sec) reloading takes me to the login page.
As I finish writing this, I'm noticing that the NAS seems to be shutting itself off for a brief period and starting up again. The power switch has always been in the "ON" position.
I would appreciate any suggestions on what to do next.
Regards,
Omar
Sorry for my bad English!
I am a network manager
My company have a NAS TeraStation Pro II Model Name
TS-HTGL/R5 F/W 1.35
when i access to File Server,It's show error:
I see on LCD,it's show:
HD1 Error E16
HD1 Not found
RAID Array 1 E14
Can't Mount
HD1-2-3-4 RAID0
Now,How do I fix it?
Thanks all!!
you cant, you kept it as RAID0 and now have had a HDD failure. So you have lost the entire contents of the array. I'm assuming you have some sort of backup in place??
Thanks for your help!
Stay here, don't have any sort backup
Now,how can i recovery data?
Error show on Administration page:
If can't recovery data,how can i reinstall all and install RAID 1 to use!
um why if you left it in raid0 do you not have a backup plan?!? Can i have your job!? :P
Anyways, contact a data recovery company, but it will cost you thousands of € potentially!
I just apply to position network manager so i don't know about backup plan.
Fortunately,director say that data don't need :D and i can format and reinstall
Error show on Administration page:
If can't recovery data,how can i reinstall all and install RAID 1 to use!
I want you show how can i reinstall all and install RAID 1 to use!
Thanks you very much!!!
First of all its saying that disk1 is not connected at all. So remove the HDD from the NAS and test it in a PC. If the disk cannot be formatted in disk management in Windows then replace the disk, log onto the web admin page of the NAS -> Disk Management -> RAID setup -> Array1 -> delete the RAID -> Wait for this to complete -> Then there will be an option to create a new RAID (ideally RAID5!!!) RAID 1 will only use 2 HDDs
Thanks so much!
I will try this in the morning !!!
Thanks!!! :D
Because I don't have key to open drive door,Now I can configure 3 HDD is HD2, HD3, HD4 on admn page?
P/S: I deleted RAID!
Thanks!