Buffalo Forums

Products => Wireless => : speedfire December 03, 2008, 05:33:43 AM

: WZR2-G300N port problem
: speedfire December 03, 2008, 05:33:43 AM

   Hi! i have problem with wzr2-g300n router, i have the latest firmware. Now i have problem with port-s opening, i want open 27015 port, but not working.

: Re: WZR2-G300N port problem
: Paul December 05, 2008, 06:28:01 PM

what is the error you are getting?

: Re: WZR2-G300N port problem
: speedfire December 06, 2008, 08:51:01 AM

   

im getting no error-s, in Lan Config i want to open 27015 udp but not working. In DMZ mod i write my lan ip there and ti should open all ports, am i right? But dmz not working too:S

In old firmware, port opening was simple, but this new one (1.52) its a problem.

Message Edited by speedfire on 12-06-2008 08:54 AM

: Re: WZR2-G300N port problem
: Paul December 06, 2008, 09:24:30 AM

try defaulting the router, this will help with a fresh start on the new firmware.  If that does not work then roll back to the first firmware.

: Re: WZR2-G300N port problem
: speedfire December 06, 2008, 10:40:16 AM

   i have defaulting it, but nothing. How to rollback the firmware?

: Re: WZR2-G300N port problem
: Paul December 06, 2008, 11:07:48 AM

Can you down load the older version?  If not you may need to contact support for your region and have them provide it for you.

: Re: WZR2-G300N port problem
: speedfire December 06, 2008, 12:53:20 PM

   **bleep** i dont remember the older version :S

: Re: WZR2-G300N port problem
: speedfire December 07, 2008, 04:31:36 AM

   I Think the older firware version was 1.00_1.26

: Re: WZR2-G300N port problem
: marvin December 08, 2008, 11:23:54 AM

   What region are you in?  That will play a factory on what the older version you had was.  If you contact your local support they can most likely provide it for you.