Buffalo Forums
Products => Wireless => : tareko August 05, 2018, 04:52:28 PM
-
Hi All,
I have a Airstation N450 Giga.
for the initial setup i am trying to connect to the router wirelessly to set it up. I connect to the router and see the admin panel.
I have the details listed below to connect to my ISP.
cannot find where to put them in the router at all?
Help please!
Thanks
Connection settings for manual connection
Always on broadband xDSL
Dial-up access (BT Line) N/A
Dial-up access (non-BT Line) N/A
Login name xxxx@plusdsl.net
Password ********
Authentication Method CHAP
Server type PPP
IP Address Server assigned
Other settings for manual connection
Primary DNS Server 212.15x.xx.xx
Secondary DNS Server 212.15x.xx.xx
POP3 (incoming mail) Server mail.plus.net
POP3 login name xxxx@plusdsl.net
POP3 password ********
IMAP Server imap.plus.net
SMTP (outgoing mail) Server relay.plus.net
Your email address yourname@xxxxxxxplus.com
News Server usenet.plus.net
NTP Server ntp.plus.net
-
What firmware version are you using?
-
hi,
Firmware: DD-WRT v24SP2-MULTI (09/27/12)
-
just found this.
Should i upgrade? If so, which one?
ftp://ftp.dd-wrt.com/betas/2014/04-18-2014-r23919/buffalo_wzr_hp_g450h/
-
any help please
-
In Setup -> Basic setup, use the following:
Connection type: PPPoE
Username: Plusnet username
Password: Plusnet Password
Apply the settings at the bottom of the page.
Done, there are no other settings needed. Make sure that your modem is connected into the blue port in the Buffalo.