Hi,
I had the same problem before about a year ago. After I updated the firmware to 1.35. it was fixed.
But recently, one of the disks (disk2) failed. After I replace it with a new disk, it could not boot up. It showed the following message
System Error E04 Can’t load kernel
I left it there for a while. This morning, I was so lucky to boot it up! It got the correct IP addresss. I could ping to it, but could not get into the Web interface.
The message now:
Emergency Mode, No Array Info
Should I update the firmware again? I have a new disk in there. Is it OK to update the firmware?
Thanks
Godwin