I'm setting up a client bridge setup and everything connects fine , but there is an issue I cannot get around. These are the steps. The main router I setup the standard wireless network and it is setup as AP. The secondary router I mirror the wireless setup of the primary. I choose client bridge on the secondary. I disable the firewall, I set the Wan port to switch, for gateway I put the ip of the main AP router which is 192.168.0.1 and I do the same for DNS. The secondary router ip is 192.168.0.253. DHCP on the primary starts at .100. On the secondary router below client bridge The ip Default GW mode has dhcp checked on it. On the secondary I create the wireless vlan. After this the bridge connection is made. Under wireless in status everything looks good. I unplug the ethernet of the secondary. I'm able to ping the 192.168.0.253, even though the ehternet cable has been pulled from a wired pc fine. I go ahead and connect a wireless system to the vlan I created on the secondary router and I'm able to ping both the gateway and outside. The issue I'm having is that it tries to go out through the 192.168.0.253 ip which is the wired port and I get 4 replies and 4 failures. Also if I plug in the wire to the secondary it slows down access tremendously to the network. like if it is sending through bother interfaces. I'm I missing something here. thanks
both routers are wzr-hp-g450h on firmware Firmware: DD-WRT v24SP2-MULTI (05/27/11) std . I tried this also with the latest alpah firmware and same issue. thanks
ping 192.168.0.1
from 192.168.0.1 sent received 3
from 192.168.0.253 destination host unreachable