Buffalo Forums
Products => Storage => : sumdumgai October 14, 2019, 07:50:10 AM
-
I have a flashing red light on my LS520 and Navigator says it's rebuilding with status I18. It's been like this for about 3 days. Is this normal and should I just let it keep running or should I do something else? Also, should it be possible to connect to the LS while it's rebuilding? I get a 'Unable to connect' message saying the drive may be too busy when I try to logon.
Thanks
Two days later and still flashing red. Any suggestions? Thanks.
-
Two days later and still flashing red. Any suggestions? Thanks.
-
The Webif should be available on every state of the nas.
-
Thanks. Regarding the WEGIF, if I try to connect via IP address, I get 'Unable to connect'. If I try 'BuffaloNas.com, I get 'Invalid BuffaloNAS.com name, but I know the name I use is correct.
-
one example for rebuilding a array
(https://i.ibb.co/Vtps7MS/Raid-wird-synchronisiert.png)
-
The exact time depends on a few factors but since it’s not raid5 parity isn’t an issue. Sometimes the rate is limited to prevent other issues but to rebuild a raid1 array or do a full fsck on a ~4tb array I would be concerned if it took more than a day.
I haven’t used my 520 much but as mentioned earlier the web interface is independent of the drives, so if it’s unavailable it would seem something is wrong.
-
Thanks. After several days of flashing amber and I18, I decided to pull the plug. I had tried to switch off, but that didn't do anything. So, I disconnected power and reconnected. It rebooted. The WEBIF then worked and disk management said Disk 2 was not formatted. I formatted it and started another rebuild. This time it finished in about 3 hours. No data loss.