: amjad175 November 17, 2008, 01:55:25 PM
Hello,
I've setup a WHR-G300N as an AP on my network. I can't access the network (or the internet) from the wireless connection.
Laptop plugged into the AP switch and GW/Firewall works fine.
Wireless connection;
AP <==> Laptop - OK (I can access the configuration page on the AP)
AP <==> GW/Firewall - OK
** Laptop <==> AP <==> GW/Firewall - No connection.
The default gateway is set in the AP (same address on the laptop). I've not setup any static routes on the AP.
Please help!
: amjad175 November 18, 2008, 01:53:05 AM
Found the incorrect setting;
"Separate feature" - (Under Basic Wireless)
Connected wireless devices can communicate with WAN side devices if this setting is enabled.
It's opposite to this, I had to untick (disable) the option and save the settings, WAN side traffic started to flow.
: reg48 November 19, 2008, 05:21:54 AM
Hi, i have WHR-G300N Ver.1.60 (R1.49/B1.09) and i have a problem.
My network provider not supporting DHCP, and i try manual settings, but there is only can type Gateway, Mask and DNS server. I do not know where can type my external IP adress.
: reg48 November 22, 2008, 03:56:52 AM
Hi again, may be i can not explane right?
I dont know where i can change my static external IP.
It is possible?
: Paul November 24, 2008, 06:48:45 PM
It is provided by the service provider.
Making the changes in the router will be on the WAN set up page of the web interface.
: reg48 December 02, 2008, 04:14:51 PM
OK, I understand, but my WAN menu doesn't have any position for ext. IP
Here is the screenshot:
May be my Internet provider gives me some IP on DHCP, but I have payed for static one and I want to have it.