On my LS220, I received a warning that drive 2 failed in my RAID1 array
Ordered a new drive to replace it.
The instructions are unclear at this point. The whole purpose of a RAID0 is to retain 100% of the data in the event one of the drives fails.
Buffalo says:
.
.
.
4 Remove the drive from the cartridge.
5 Install a new Buffalo OP-HD/LS series drive in the cartridge.
6 Replace the four screws.
7 Insert the new drive in the empty slot.
8 Close the front panel.
9 Connect all cables, then turn on the LinkStation.
10
For RAID 0
Navigate to Drives - RAID in Advanced Settings. Select the array with the error, then click Delete RAID Array.
Navigate to Drives - Drives. Choose the new drive (the unformatted one) and format the drive. After formatting the
drive, change the RAID mode.
Will this delete all of the data on my remaining GOOD drive? I'm not about to risk losing everything I have on there. The instructions leave a bit to be desired.