Hello Jotin
I've now tested with the following scenario:
- Leave a laptop on and running NasNavi, and then switch the unit to on
- After it is fully started up, then let it rest in that state
- Then turn the unit to 'auto'
- make sure that NasNavi keeps it on
- Then turn the laptop off
When I do this the light on the NAS unit flashes as if it's going to turn off, it sits in this state forever, (well, I tested for about 30mins). Then I get inpatient and turn the unit to the 'off' position, it still continues to flash, (left it for another ~30mins). In the end I had to pull the plug :(
I repeated this a couple of times to make sure that it was consistant behaviour.
Please adise what I should try. I am tempted to downgrade to a f/w version where the 'auto' mode still works.
Best regards,
Nitin