Wireless

[scajjr2]

Just got my WZR-HP-G300NH today and love it. Gig LAN is great, just wish Buffalo would make a 32-bit cardbus nFiniti laptop card (using an Ralink-based Encore N card in fiance's laptop, gets 130mps).

Can't seem to find in the router's web interface how to change the default IP for the router. If someone could point me in the right direction I'd appreciate it.

Sam

[dolpli]

Hello

I am also a new owner of WZR-HP-G300NH for about a week.

You may go to 'Internet/LAN' -> LAN -> LAN side IP address

and then change the IP of the router and apply the setting.

It is the first time I have a buffalo router and I felt a little bit uncomfortable with its default IP since most routers of other brands have IP of 192.168.1.1 instead of 192.168.11.1.

BTW, I am glad with its overall performance, though disappointed of the firmware due to its limited settings, slow response & BT functions. I just wish buffalo could improve the firmware asap

[scajjr2]

Thanks I thought that might have been it but wasn't quite sure. I did change the band from 20mhz to 40 and now the laptop connects at a constant 270mbps.

I have an older HP laserjet on an old Jetdirect that is a royal pain to change the ip address on so I want to change the router's IP so I can get the HP back on the network.

Sam

Message Edited by scajjr2 on 07-10-2009 07:30 PM