Storage

[Wagaweze]

Hi all.

I need to know if im doing anything wrong trying to get my HD H160LAN out of EM mode.

Ive tried re-flashing over the network and direct from pc to device. With firewall off and virus scanner off.  tryed on windwos 7 and xp.

any ideas? If the hdd is dead will the ROM still flash?

[JoshC]

When the unit is in Em mode it is running off of the flash.  Make sure Nas Navi is diabled and make sure there on the same subnets.

[Wagaweze]

what is Nas Navi? and ill check the subnets

[JoshC]

Nas Naviagator is a client utility.  Go to buffalotech.com/support/downloads

Download and install the 2.24 version

[Wagaweze]

downloaded an installed it gives me no extra options that i can see.

Just tells me my drive is in EM mode and need s firmware reset.

Cant find anywhere to disable Nas Navi.

[JoshC]

Exit out of it in your system tray.  Did you download the firmware hardwired into your router or did you download it wirelessly?

[Wagaweze]

Wired not wireless.

I could try redownloading.

[Wagaweze]

Just so you know which one im using its the:

HD-HLAN_FW147.zip

maybe  i could try 144? But the link doesnt work so i cant download that one.

[Wagaweze]

still no go after re download. What is EM mode? It doesnt make sense to even have this mode does it?

So lets run through this.

I connect the device straight to my PC running windows xp with a straight cat6 cable.

i set the comp ip to 192.168.11.140, 255.255.255.0

the switch on the back of the device is set to straight

i deactivate virus scanner and firewall

i plug in the power and the network to the device and power it on

when the power eld stops flashing i open the flashing program

i click reflash and put in no password

then i wait and it fails. Doing anythign wrong?

[Wagaweze]

Also the DIAG LED flashes red a few seconds before it fails.