Author Topic: Linkstation LS-WX2.0TL solid red function light  (Read 7319 times)

blauer

  • Calf
  • *
  • Posts: 1
Linkstation LS-WX2.0TL solid red function light
« on: June 07, 2011, 04:03:17 AM »

Hello,

Could not find anything in the manual or in the forums about this :

my linkstation duo LS-WX2.0TL has the function light solid red.

Turning it on/off did not change anything.

Nothing changed in my configuration (computer, network ...)

The nas navigator cannot see the linkstation, hard drive are not spinning, the linkstation seems just dead !

I have no clue about what is going on. Any idea ?


Jotin

  • Big Bull
  • *****
  • Posts: 4200
Re: Linkstation LS-WX2.0TL solid red function light
« Reply #1 on: June 07, 2011, 09:59:15 AM »

I would unplug it and then follow this process.

 

Please switch the unit to off and wait until the lights are off.

Hold the function button for 10 seconds while it is still off.

While still holding the function button after 10 seconds please flip the switch to on.

Once the function light begins to blink release the function button and press it again for one second.

Wait until the power light is solid and this will restore your unit.

This process will not delete any data and will only restore the admin password and set the IP address back to DHCP.

 

It sounds like its in EM mode. You should be able to flash the firmware on the unit.