Author Topic: When is DTCP-IP used on LS-WXL?  (Read 918 times)

Phonon

  • Calf
  • *
  • Posts: 2
When is DTCP-IP used on LS-WXL?
« on: February 27, 2011, 08:42:43 pm »

Hi there,

 

  I'm trying to use DTCP-IP on the LS-WXL, but I can't figure out when DTCP-IP is used.  I have upgraded the firmware to version 1.40, and set the DTCP-IP feature to 'Enabled' - however, all the content is still not protected.

 

  When does the device use DTCP-IP?  (is it limited to some type of content?  Do I need to get the content on the device in a specific way?) 

 

  Is there a way to force it to always stream with DTCP-IP?

 

Cheers,

Andrew


Phonon

  • Calf
  • *
  • Posts: 2
Re: When is DTCP-IP used on LS-WXL?
« Reply #1 on: April 21, 2011, 02:43:35 pm »

Anyone have an answer to this?

 

Or another way to put it - in what situation did you find the storage device used DTCP-IP?  I just need one or two situations so I can verify its interop.

 

Cheers,

Andrew


drmemory

  • Big Bull
  • *****
  • Posts: 1152
Re: When is DTCP-IP used on LS-WXL?
« Reply #2 on: March 20, 2012, 11:35:36 am »

DTCP-IP is not used in the USA. It is used in Japan and parts of Europe. If the DTCP-IP key becomes corrupt, then you may need to re-validate the key with the DTCP-IP update. If router settings are incorrect, or if there is a firewall present, this re-validation may not succeed. In this case, you may be able to resolve the issue by reloading the firmware.