LS-CHL install problem.
I have recently purchased a LS-CH 1.0TL and am really struggling to get it installed.
I have followed all the instructions as detailed in the meagre instructions and after finding the linkstation on the network it says "Did not answer to replay command" (or similair). After this setup finishes and says unable to setup linkstation, after this the install package will not find the linkstation again and I have to revert to factory settings. The linkstation has been given an IP address but I am unable to ping it and via by Home Hub it shows as inactive. I have also tried to plug the drive directly into a PC and get exactly the same response, I have switched off AV and all firewalls and still get same issue.
Has anyone had this before or have any advice on this?
Thanks in advance,
Paul